Vinyl Fence Cost in Hattiesburg, MS (2026)

Home › Fencing › Mississippi › Hattiesburg
Vinyl Fence Cost in Hattiesburg, MS (2026)
Prices updated August 2026
Hattiesburg · per linear ft
$25.88 – $55.46

Vinyl Fence costs $25.88 to $55.46 per linear ft in Hattiesburg in 2026. For a 150-foot run, expect $3,882 – $8,319 installed, typically near $6,101. That is essentially in line with the Mississippi state average.

Typical linear ft
$40.67
Metro premium
In line
Frost depth
6 in
Typical permit
$250

Hattiesburg vinyl fence cost calculator

Estimated installed cost
–
–

Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.

Why Hattiesburg costs more than the rest of Mississippi

Hattiesburg carries essentially the same rate as the Mississippi statewide figure. Wages, permitting, and site access here track close to the statewide norm, so the premium metro buyers often pay elsewhere is much smaller in Hattiesburg.

Statewide, Mississippi averages $25.88 to $55.46 per linear ft, against $25.88 to $55.46 inside Hattiesburg. Suburbs on the metro fringe usually fall between the two.

Vinyl Fence cost by project size in Hattiesburg

Project sizeHattiesburg rangeTypical
50 ft$1,294 – $2,773$2,034
100 ft$2,588 – $5,546$4,067
150 ft$3,882 – $8,319$6,101
200 ft$5,176 – $11,092$8,134
250 ft$6,470 – $13,865$10,168
300 ft$7,764 – $16,638$12,201
400 ft$10,352 – $22,184$16,268
500 ft$12,940 – $27,730$20,335

Where the money actually goes

For a 150-foot run in Hattiesburg at roughly $6,101, a typical bill splits like this:

Line itemShareCost
Labor42%$2,562
Materials44%$2,684
Site prep & equipment9%$549
Overhead, disposal & finishing6%$366

The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting site prep, not a genuine bargain.

Hattiesburg compared with other Mississippi markets

AreaCost per linear ftvs Hattiesburg
Jackson$27.18 – $58.24+5%
Gulfport$26.66 – $57.13+3%
Mississippi average$25.88 – $55.460%

Ground conditions and code in Hattiesburg

Mississippi has a shallow frost line of roughly 6 inches, so frost-depth excavation adds very little to a typical project here. Local codes focus more on soil bearing and drainage.

Permits in Hattiesburg

A residential permit for this work typically runs around $250 in Mississippi, and metro jurisdictions like Hattiesburg usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Hattiesburg building department before work begins.

Hiring in Hattiesburg

Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Mississippi.

Frequently asked questions

How much does vinyl fence cost in Hattiesburg?

In 2026, vinyl fence costs $25.88 to $55.46 per linear ft in Hattiesburg. For a 150-foot run, the installed total typically lands between $3,882 and $8,319.

Is Hattiesburg more expensive than the rest of Mississippi?

Not meaningfully. Hattiesburg prices essentially in line with the Mississippi statewide average.

Do I need a permit in Hattiesburg?

Most work of this type and value requires a permit. Budget around $250 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.

How do I compare quotes in Hattiesburg?

Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full vinyl fence calculator →

Methodology. Metro figures apply a local wage and permitting premium to the Mississippi state rate, which itself applies a BLS-derived construction wage index to the labor share of a national 2026 baseline. Planning estimates, not quotes. See our full methodology.

Leave a Comment