Stamped Concrete Cost in Casper, WY (2026)

HomeConcreteWyoming › Casper
Stamped Concrete Cost in Casper, WY (2026)
BLS OEWS 2025 wage data · updated August 2026
Casper · per sq ft
$12.41 – $26.73

Stamped Concrete costs $12.41 to $26.73 per sq ft in Casper in 2026. For a 400 sq ft project, expect $4,965 – $10,694 installed, typically near $7,829. That is about 4% below the Wyoming average.

Typical sq ft
$19.57
vs state average
−4%
Local construction wage
$28.98
Frost depth
48 in

Casper stamped concrete calculator

Estimated installed cost

Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.

Why Casper runs below the Wyoming average

Construction wages in Casper average $28.98 per hour against $30.86 statewide. Casper sits below the Wyoming average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.

Labor is about 58% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.

Stamped Concrete cost by project size in Casper

Project sizeCasper rangeTypical
100 sq ft$1,241 – $2,673$1,957
200 sq ft$2,483 – $5,347$3,915
300 sq ft$3,724 – $8,020$5,872
400 sq ft$4,965 – $10,694$7,829
600 sq ft$7,448 – $16,041$11,744
800 sq ft$9,930 – $21,388$15,659
1,000 sq ft$12,413 – $26,735$19,574
1,500 sq ft$18,619 – $40,102$29,361

Where the money goes

For a 400 sq ft project in Casper at roughly $7,829, a typical bill splits like this:

Line itemShareCost
Labor58%$4,541
Materials28%$2,192
Site prep & equipment8%$626
Overhead, disposal & finishing6%$470

Casper compared with other Wyoming markets

AreaCost per sq ftvs Casper
Western Wyoming nonmetropolitan area$12.89 – $27.76+4%
Eastern Wyoming nonmetropolitan area$13.03 – $28.07+5%
Cheyenne$12.70 – $27.36+2%
Wyoming average$12.86 – $27.71+4%

Ground conditions and code in Casper

Casper sits in IECC zone 6-7 (cold) with a design frost depth of about 48 inches. Footings and posts must extend below that line, which adds excavation depth and concrete volume that warm-climate estimates leave out.

Permits in Casper

A residential permit for this work typically runs around $300 in Wyoming. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Casper building department before work begins.

Hiring in Casper

Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Wyoming.

Frequently asked questions

How much does stamped concrete cost in Casper?

In 2026, stamped concrete costs $12.41 to $26.73 per sq ft in Casper. For a 400 sq ft project, the installed total typically lands between $4,965 and $10,694.

Is Casper more expensive than the rest of Wyoming?

No. Casper actually runs about 4% below the Wyoming average. Local construction wages are $28.98/hr against $30.86/hr statewide.

Do I need a permit in Casper?

Most work of this type and value requires a permit. Budget around $300 in Wyoming and allow extra time for review in metro jurisdictions.

How do I compare quotes in Casper?

Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full stamped concrete calculator →

Methodology. Local pricing applies the Casper construction wage from the BLS Occupational Employment and Wage Statistics (2025 release, $28.98/hr) to the labor share of a national 2026 cost baseline. Materials are held at national prices. Figures refresh automatically with each BLS release. Planning estimates, not quotes. See our full methodology.

Leave a Comment