Concrete Driveway costs $8.07 to $18.16 per sq ft in Bellevue in 2026. For a 400 sq ft project, expect $3,228 – $7,263 installed, typically near $5,246. That is about 4% above the Nebraska state average.
Bellevue concrete driveway cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Bellevue costs more than the rest of Nebraska
Bellevue carries roughly a 4% premium over the Nebraska statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Nebraska averages $7.76 to $17.46 per sq ft, against $8.07 to $18.16 inside Bellevue. Suburbs on the metro fringe usually fall between the two.
Concrete Driveway cost by project size in Bellevue
| Project size | Bellevue range | Typical |
|---|---|---|
| 10×10 (100 sq ft) | $807 – $1,816 | $1,311 |
| 12×12 (144 sq ft) | $1,162 – $2,615 | $1,888 |
| 12×16 (192 sq ft) | $1,550 – $3,486 | $2,518 |
| 16×20 (320 sq ft) | $2,583 – $5,811 | $4,197 |
| 20×20 (400 sq ft) | $3,228 – $7,263 | $5,246 |
| 24×24 (576 sq ft) | $4,649 – $10,459 | $7,554 |
| 30×40 (1,200 sq ft) | $9,684 – $21,790 | $15,737 |
Bellevue compared with other Nebraska markets
| Area | Cost per sq ft | vs Bellevue |
|---|---|---|
| Omaha | $8.30 – $18.68 | +3% |
| Lincoln | $7.99 – $17.98 | -1% |
| Nebraska average | $7.76 – $17.46 | −4% |
Ground conditions and code in Bellevue
Permits in Bellevue
A residential permit for this work typically runs around $300 in Nebraska, and metro jurisdictions like Bellevue usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Bellevue building department before work begins.
Hiring in Bellevue
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Nebraska.
Frequently asked questions
How much does concrete driveway cost in Bellevue?
In 2026, concrete driveway costs $8.07 to $18.16 per sq ft in Bellevue. For a 400 sq ft project, the installed total typically lands between $3,228 and $7,263.
Is Bellevue more expensive than the rest of Nebraska?
Yes. Bellevue runs about 4% above the Nebraska statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Bellevue?
Most work of this type and value requires a permit. Budget around $300 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Bellevue?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full concrete driveway calculator →