Chain Link Fence Cost in Hattiesburg, MS (2026)

HomeFencingMississippi › Hattiesburg
Chain Link Fence Cost in Hattiesburg, MS (2026)
Prices updated August 2026
Hattiesburg · per linear ft
$11.03 – $27.57

Chain Link Fence costs $11.03 to $27.57 per linear ft in Hattiesburg in 2026. For a 150-foot run, expect $1,655 – $4,136 installed, typically near $2,895. That is essentially in line with the Mississippi state average.

Typical linear ft
$19.30
Metro premium
In line
Frost depth
6 in
Typical permit
$250

Hattiesburg chain link fence calculator

Estimated installed cost

Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.

Why Hattiesburg costs more than the rest of Mississippi

Hattiesburg carries essentially the same rate as the Mississippi statewide figure. Wages, permitting, and site access here track close to the statewide norm, so the premium metro buyers often pay elsewhere is much smaller in Hattiesburg.

Statewide, Mississippi averages $11.03 to $27.57 per linear ft, against $11.03 to $27.57 inside Hattiesburg. Suburbs on the metro fringe usually fall between the two.

Chain Link Fence cost by project size in Hattiesburg

Project sizeHattiesburg rangeTypical
50 ft$551 – $1,379$965
100 ft$1,103 – $2,757$1,930
150 ft$1,654 – $4,136$2,895
200 ft$2,206 – $5,514$3,860
250 ft$2,757 – $6,893$4,825
300 ft$3,308 – $8,271$5,790
400 ft$4,411 – $11,028$7,720
500 ft$5,514 – $13,785$9,650

Where the money actually goes

For a 150-foot run in Hattiesburg at roughly $2,895, a typical bill splits like this:

Line itemShareCost
Labor45%$1,303
Materials41%$1,194
Site prep & equipment8%$239
Overhead, disposal & finishing6%$159

The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting preparation, not a genuine bargain.

Hattiesburg compared with other Mississippi markets

AreaCost per linear ftvs Hattiesburg
Jackson$11.58 – $28.95+5%
Gulfport$11.36 – $28.40+3%
Mississippi average$11.03 – $27.570%

Frost depth and code requirements in Hattiesburg

Mississippi has a shallow frost line of roughly 6 inches, so frost-depth excavation adds very little to a typical project here. Local codes focus more on soil bearing and drainage.

Permits in Hattiesburg

A residential permit for this work typically runs around $250 in Mississippi, and metro jurisdictions like Hattiesburg usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Hattiesburg building department before work begins.

Hiring in Hattiesburg

Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same scope and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Mississippi.

Frequently asked questions

How much does chain link fence cost in Hattiesburg?

In 2026, chain link fence costs $11.03 to $27.57 per linear ft in Hattiesburg. For a 150-foot run, the installed total typically lands between $1,655 and $4,136.

Is Hattiesburg more expensive than the rest of Mississippi?

Not meaningfully. Hattiesburg prices essentially in line with the Mississippi statewide average.

Do I need a permit in Hattiesburg?

Most work of this type and value requires a permit. Budget around $250 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.

How do I compare quotes in Hattiesburg?

Insist on three written, itemised quotes covering identical scope, materials, and preparation. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full chain link fence calculator →

Methodology. Metro figures apply a local wage and permitting premium to the Mississippi state rate, which itself applies a BLS-derived construction wage index to the labor share of a national 2026 baseline. Planning estimates, not quotes. See our full methodology.

Leave a Comment