Chain Link Fence Cost in Nashville, TN (2026)

HomeFencingTennessee › Nashville
Chain Link Fence Cost in Nashville, TN (2026)
BLS OEWS 2025 wage data · updated August 2026
Nashville · per linear ft
$11.51 – $28.77

Chain Link Fence costs $11.51 to $28.77 per linear ft in Nashville in 2026. For a 150-foot run, expect $1,726 – $4,316 installed, typically near $3,021. That is about 2% above the Tennessee average.

Typical linear ft
$20.14
vs state average
+2%
Local construction wage
$28.56
Frost depth
15 in

Nashville chain link fence calculator

Estimated installed cost

Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.

Why Nashville runs above the Tennessee average

Construction wages in Nashville average $28.56 per hour against $27.17 statewide, so labor-heavy work prices above the Tennessee norm here.

Labor is about 45% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.

Chain Link Fence cost by project size in Nashville

Project sizeNashville rangeTypical
50 ft$575 – $1,439$1,007
100 ft$1,151 – $2,877$2,014
150 ft$1,726 – $4,316$3,021
200 ft$2,302 – $5,755$4,028
250 ft$2,877 – $7,193$5,035
300 ft$3,453 – $8,632$6,042
400 ft$4,604 – $11,509$8,056
500 ft$5,755 – $14,387$10,071

Where the money goes

For a 150-foot run in Nashville at roughly $3,021, a typical bill splits like this:

Line itemShareCost
Labor45%$1,360
Materials41%$1,239
Site prep & equipment8%$242
Overhead, disposal & finishing6%$181

Nashville compared with other Tennessee markets

AreaCost per linear ftvs Nashville
Memphis$11.28 – $28.19−2%
Knoxville$11.20 – $27.99−3%
Chattanooga$11.32 – $28.29−2%
Kingsport$11.10 – $27.75−4%
Tennessee average$11.27 – $28.18−2%

Ground conditions and code in Nashville

Nashville sits in IECC zone 4 (mixed) with a design frost depth of about 15 inches. Footings and posts must extend below that line, which adds excavation depth and concrete volume that warm-climate estimates leave out.

Permits in Nashville

A residential permit for this work typically runs around $350 in Tennessee. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Nashville building department before work begins.

Hiring in Nashville

Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Tennessee.

Frequently asked questions

How much does chain link fence cost in Nashville?

In 2026, chain link fence costs $11.51 to $28.77 per linear ft in Nashville. For a 150-foot run, the installed total typically lands between $1,726 and $4,316.

Is Nashville more expensive than the rest of Tennessee?

Yes. Nashville runs about 2% above the Tennessee average, because local construction wages ($28.56/hr) sit above the statewide figure of $27.17/hr.

Do I need a permit in Nashville?

Most work of this type and value requires a permit. Budget around $350 in Tennessee and allow extra time for review in metro jurisdictions.

How do I compare quotes in Nashville?

Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full chain link fence calculator →

Methodology. Local pricing applies the Nashville construction wage from the BLS Occupational Employment and Wage Statistics (2025 release, $28.56/hr) to the labor share of a national 2026 cost baseline. Materials are held at national prices. Figures refresh automatically with each BLS release. Planning estimates, not quotes. See our full methodology.

Leave a Comment