Wood Fence costs $20.03 to $50.08 per linear ft in Frederick in 2026. For a 150-foot run, expect $3,005 – $7,512 installed, typically near $5,258. That is about 7% above the Maryland state average.
Frederick wood fence calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Frederick costs more than the rest of Maryland
Frederick carries roughly a 7% premium over the Maryland statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Maryland averages $18.72 to $46.80 per linear ft, against $20.03 to $50.08 inside Frederick. Suburbs on the metro fringe usually fall between the two.
Wood Fence cost by project size in Frederick
| Project size | Frederick range | Typical |
|---|---|---|
| 50 ft | $1,002 – $2,504 | $1,753 |
| 100 ft | $2,003 – $5,008 | $3,505 |
| 150 ft | $3,005 – $7,511 | $5,258 |
| 200 ft | $4,006 – $10,015 | $7,011 |
| 250 ft | $5,008 – $12,519 | $8,763 |
| 300 ft | $6,009 – $15,023 | $10,516 |
| 400 ft | $8,012 – $20,030 | $14,021 |
| 500 ft | $10,015 – $25,038 | $17,526 |
Where the money actually goes
For a 150-foot run in Frederick at roughly $5,258, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 50% | $2,629 |
| Materials | 38% | $1,972 |
| Site prep & equipment | 8% | $395 |
| Overhead, disposal & finishing | 5% | $263 |
The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting preparation, not a genuine bargain.
Frederick compared with other Maryland markets
| Area | Cost per linear ft | vs Frederick |
|---|---|---|
| Baltimore | $20.40 – $51.01 | +2% |
| Silver Spring | $21.72 – $54.29 | +8% |
| Maryland average | $18.72 – $46.80 | −7% |
Frost depth and code requirements in Frederick
Permits in Frederick
A residential permit for this work typically runs around $500 in Maryland, and metro jurisdictions like Frederick usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Frederick building department before work begins.
Hiring in Frederick
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same scope and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Maryland.
Frequently asked questions
How much does wood fence cost in Frederick?
In 2026, wood fence costs $20.03 to $50.08 per linear ft in Frederick. For a 150-foot run, the installed total typically lands between $3,005 and $7,512.
Is Frederick more expensive than the rest of Maryland?
Yes. Frederick runs about 7% above the Maryland statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Frederick?
Most work of this type and value requires a permit. Budget around $500 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Frederick?
Insist on three written, itemised quotes covering identical scope, materials, and preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full wood fence calculator →