Vinyl Fence Cost in Manhattan, KS (2026)

HomeFencingKansas › Manhattan
Vinyl Fence Cost in Manhattan, KS (2026)
BLS OEWS 2025 wage data · updated August 2026
Manhattan · per linear ft
$26.93 – $57.70

Vinyl Fence costs $26.93 to $57.70 per linear ft in Manhattan in 2026. For a 150-foot run, expect $4,039 – $8,656 installed, typically near $6,347. That is essentially in line with the Kansas average.

Typical linear ft
$42.32
vs state average
In line
Local construction wage
$28.56
Frost depth
30 in

Manhattan vinyl fence calculator

Estimated installed cost

Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.

How Manhattan compares with the rest of Kansas

Construction wages in Manhattan average $28.56 per hour against $28.89 statewide, so pricing tracks the Kansas norm closely.

Labor is about 42% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.

Vinyl Fence cost by project size in Manhattan

Project sizeManhattan rangeTypical
50 ft$1,346 – $2,885$2,116
100 ft$2,693 – $5,770$4,232
150 ft$4,039 – $8,656$6,347
200 ft$5,386 – $11,541$8,463
250 ft$6,732 – $14,426$10,579
300 ft$8,079 – $17,311$12,695
400 ft$10,771 – $23,082$16,927
500 ft$13,464 – $28,852$21,158

Where the money goes

For a 150-foot run in Manhattan at roughly $6,347, a typical bill splits like this:

Line itemShareCost
Labor42%$2,666
Materials44%$2,793
Site prep & equipment8%$508
Overhead, disposal & finishing6%$381

Manhattan compared with other Kansas markets

AreaCost per linear ftvs Manhattan
Wichita$26.60 – $57.01−1%
Topeka$26.89 – $57.610%
Lawrence$27.31 – $58.51+1%
Kansas average$27.05 – $57.960%

Ground conditions and code in Manhattan

Manhattan sits in IECC zone 5 (cold) with a design frost depth of about 30 inches. Footings and posts must extend below that line, which adds excavation depth and concrete volume that warm-climate estimates leave out.

Permits in Manhattan

A residential permit for this work typically runs around $300 in Kansas. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Manhattan building department before work begins.

Hiring in Manhattan

Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Kansas.

Frequently asked questions

How much does vinyl fence cost in Manhattan?

In 2026, vinyl fence costs $26.93 to $57.70 per linear ft in Manhattan. For a 150-foot run, the installed total typically lands between $4,039 and $8,656.

Is Manhattan more expensive than the rest of Kansas?

Not meaningfully. Manhattan prices track the Kansas average closely.

Do I need a permit in Manhattan?

Most work of this type and value requires a permit. Budget around $300 in Kansas and allow extra time for review in metro jurisdictions.

How do I compare quotes in Manhattan?

Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full vinyl fence calculator →

Methodology. Local pricing applies the Manhattan construction wage from the BLS Occupational Employment and Wage Statistics (2025 release, $28.56/hr) to the labor share of a national 2026 cost baseline. Materials are held at national prices. Figures refresh automatically with each BLS release. Planning estimates, not quotes. See our full methodology.

Leave a Comment