Vinyl Fence costs $27.37 to $58.64 per linear ft in Lexington Park in 2026. For a 150-foot run, expect $4,105 – $8,796 installed, typically near $6,451. That is about 2% below the Maryland average.
Lexington Park vinyl fence calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Lexington Park runs below the Maryland average
Construction wages in Lexington Park average $29.75 per hour against $31.34 statewide. Lexington Park sits below the Maryland average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 42% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Vinyl Fence cost by project size in Lexington Park
| Project size | Lexington Park range | Typical |
|---|---|---|
| 50 ft | $1,368 – $2,932 | $2,150 |
| 100 ft | $2,737 – $5,864 | $4,300 |
| 150 ft | $4,105 – $8,796 | $6,451 |
| 200 ft | $5,473 – $11,729 | $8,601 |
| 250 ft | $6,842 – $14,661 | $10,751 |
| 300 ft | $8,210 – $17,593 | $12,901 |
| 400 ft | $10,947 – $23,457 | $17,202 |
| 500 ft | $13,683 – $29,322 | $21,502 |
Where the money goes
For a 150-foot run in Lexington Park at roughly $6,451, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 42% | $2,709 |
| Materials | 44% | $2,838 |
| Site prep & equipment | 8% | $516 |
| Overhead, disposal & finishing | 6% | $387 |
Lexington Park compared with other Maryland markets
| Area | Cost per linear ft | vs Lexington Park |
|---|---|---|
| Baltimore | $27.65 – $59.25 | +1% |
| Maryland nonmetropolitan area | $26.39 – $56.56 | −4% |
| Hagerstown | $26.48 – $56.73 | −3% |
| Salisbury | $27.21 – $58.32 | −1% |
| Maryland average | $27.96 – $59.92 | +2% |
Ground conditions and code in Lexington Park
Permits in Lexington Park
A residential permit for this work typically runs around $500 in Maryland. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Lexington Park building department before work begins.
Hiring in Lexington Park
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Maryland.
Frequently asked questions
How much does vinyl fence cost in Lexington Park?
In 2026, vinyl fence costs $27.37 to $58.64 per linear ft in Lexington Park. For a 150-foot run, the installed total typically lands between $4,105 and $8,796.
Is Lexington Park more expensive than the rest of Maryland?
No. Lexington Park actually runs about 2% below the Maryland average. Local construction wages are $29.75/hr against $31.34/hr statewide.
Do I need a permit in Lexington Park?
Most work of this type and value requires a permit. Budget around $500 in Maryland and allow extra time for review in metro jurisdictions.
How do I compare quotes in Lexington Park?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full vinyl fence calculator →