Vinyl Fence costs $28.84 to $61.79 per linear ft in Bend in 2026. For a 150-foot run, expect $4,325 – $9,269 installed, typically near $6,797. That is about 4% below the Oregon average.
Bend vinyl fence calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Bend runs below the Oregon average
Construction wages in Bend average $33.64 per hour against $36.54 statewide. Bend sits below the Oregon average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 42% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Vinyl Fence cost by project size in Bend
| Project size | Bend range | Typical |
|---|---|---|
| 50 ft | $1,442 – $3,090 | $2,266 |
| 100 ft | $2,884 – $6,179 | $4,531 |
| 150 ft | $4,325 – $9,269 | $6,797 |
| 200 ft | $5,767 – $12,358 | $9,063 |
| 250 ft | $7,209 – $15,448 | $11,329 |
| 300 ft | $8,651 – $18,538 | $13,594 |
| 400 ft | $11,535 – $24,717 | $18,126 |
| 500 ft | $14,418 – $30,896 | $22,657 |
Where the money goes
For a 150-foot run in Bend at roughly $6,797, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 42% | $2,855 |
| Materials | 44% | $2,991 |
| Site prep & equipment | 8% | $544 |
| Overhead, disposal & finishing | 6% | $408 |
Bend compared with other Oregon markets
| Area | Cost per linear ft | vs Bend |
|---|---|---|
| Portland | $31.00 – $66.42 | +7% |
| Salem | $28.80 – $61.70 | 0% |
| Eugene | $28.36 – $60.77 | −2% |
| Medford | $28.43 – $60.91 | −1% |
| Oregon average | $29.92 – $64.11 | +4% |
Ground conditions and code in Bend
Permits in Bend
A residential permit for this work typically runs around $600 in Oregon. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Bend building department before work begins.
Hiring in Bend
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Oregon.
Frequently asked questions
How much does vinyl fence cost in Bend?
In 2026, vinyl fence costs $28.84 to $61.79 per linear ft in Bend. For a 150-foot run, the installed total typically lands between $4,325 and $9,269.
Is Bend more expensive than the rest of Oregon?
No. Bend actually runs about 4% below the Oregon average. Local construction wages are $33.64/hr against $36.54/hr statewide.
Do I need a permit in Bend?
Most work of this type and value requires a permit. Budget around $600 in Oregon and allow extra time for review in metro jurisdictions.
How do I compare quotes in Bend?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full vinyl fence calculator →