Privacy Fence costs $30.16 to $72.38 per linear ft in Silver Spring in 2026. For a 150-foot run, expect $4,524 – $10,858 installed, typically near $7,691. That is about 16% above the Maryland state average.
Silver Spring privacy fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Silver Spring costs more than the rest of Maryland
Silver Spring carries roughly a 16% premium over the Maryland statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Maryland averages $26.00 to $62.40 per linear ft, against $30.16 to $72.38 inside Silver Spring. Suburbs on the metro fringe usually fall between the two.
Privacy Fence cost by project size in Silver Spring
| Project size | Silver Spring range | Typical |
|---|---|---|
| 50 ft | $1,508 – $3,619 | $2,564 |
| 100 ft | $3,016 – $7,238 | $5,127 |
| 150 ft | $4,524 – $10,858 | $7,691 |
| 200 ft | $6,032 – $14,477 | $10,254 |
| 250 ft | $7,540 – $18,096 | $12,818 |
| 300 ft | $9,048 – $21,715 | $15,382 |
| 400 ft | $12,064 – $28,954 | $20,509 |
| 500 ft | $15,080 – $36,192 | $25,636 |
Silver Spring compared with other Maryland markets
| Area | Cost per linear ft | vs Silver Spring |
|---|---|---|
| Baltimore | $28.34 – $68.02 | -6% |
| Frederick | $27.82 – $66.77 | -8% |
| Maryland average | $26.00 – $62.40 | −16% |
Ground conditions and code in Silver Spring
Permits in Silver Spring
A residential permit for this work typically runs around $500 in Maryland, and metro jurisdictions like Silver Spring usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Silver Spring building department before work begins.
Hiring in Silver Spring
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Maryland.
Frequently asked questions
How much does privacy fence cost in Silver Spring?
In 2026, privacy fence costs $30.16 to $72.38 per linear ft in Silver Spring. For a 150-foot run, the installed total typically lands between $4,524 and $10,858.
Is Silver Spring more expensive than the rest of Maryland?
Yes. Silver Spring runs about 16% above the Maryland statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Silver Spring?
Most work of this type and value requires a permit. Budget around $500 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Silver Spring?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →