Privacy Fence costs $31.86 to $76.46 per linear ft in Seattle in 2026. For a 150-foot run, expect $4,779 – $11,470 installed, typically near $8,124. That is about 18% above the Washington state average.
Seattle privacy fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Seattle costs more than the rest of Washington
Seattle carries roughly a 18% premium over the Washington statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Washington averages $27.00 to $64.80 per linear ft, against $31.86 to $76.46 inside Seattle. Suburbs on the metro fringe usually fall between the two.
Privacy Fence cost by project size in Seattle
| Project size | Seattle range | Typical |
|---|---|---|
| 50 ft | $1,593 – $3,823 | $2,708 |
| 100 ft | $3,186 – $7,646 | $5,416 |
| 150 ft | $4,779 – $11,470 | $8,124 |
| 200 ft | $6,372 – $15,293 | $10,832 |
| 250 ft | $7,965 – $19,116 | $13,541 |
| 300 ft | $9,558 – $22,939 | $16,249 |
| 400 ft | $12,744 – $30,586 | $21,665 |
| 500 ft | $15,930 – $38,232 | $27,081 |
Seattle compared with other Washington markets
| Area | Cost per linear ft | vs Seattle |
|---|---|---|
| Spokane | $27.81 – $66.74 | -13% |
| Tacoma | $29.43 – $70.63 | -8% |
| Washington average | $27.00 – $64.80 | −18% |
Ground conditions and code in Seattle
Permits in Seattle
A residential permit for this work typically runs around $700 in Washington, and metro jurisdictions like Seattle usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Seattle building department before work begins.
Hiring in Seattle
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Washington.
Frequently asked questions
How much does privacy fence cost in Seattle?
In 2026, privacy fence costs $31.86 to $76.46 per linear ft in Seattle. For a 150-foot run, the installed total typically lands between $4,779 and $11,470.
Is Seattle more expensive than the rest of Washington?
Yes. Seattle runs about 18% above the Washington statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Seattle?
Most work of this type and value requires a permit. Budget around $700 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Seattle?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →