Privacy Fence costs $31.63 to $75.92 per linear ft in Los Angeles in 2026. For a 150-foot run, expect $4,745 – $11,389 installed, typically near $8,067. That is about 14% above the California state average.
Los Angeles privacy fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Los Angeles costs more than the rest of California
Los Angeles carries roughly a 14% premium over the California statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, California averages $27.75 to $66.60 per linear ft, against $31.63 to $75.92 inside Los Angeles. Suburbs on the metro fringe usually fall between the two.
Privacy Fence cost by project size in Los Angeles
| Project size | Los Angeles range | Typical |
|---|---|---|
| 50 ft | $1,582 – $3,796 | $2,689 |
| 100 ft | $3,163 – $7,592 | $5,378 |
| 150 ft | $4,745 – $11,389 | $8,067 |
| 200 ft | $6,327 – $15,185 | $10,756 |
| 250 ft | $7,909 – $18,981 | $13,445 |
| 300 ft | $9,490 – $22,777 | $16,134 |
| 400 ft | $12,654 – $30,370 | $21,512 |
| 500 ft | $15,817 – $37,962 | $26,890 |
Los Angeles compared with other California markets
| Area | Cost per linear ft | vs Los Angeles |
|---|---|---|
| San Francisco | $36.07 – $86.58 | +14% |
| San Diego | $31.08 – $74.59 | -2% |
| California average | $27.75 – $66.60 | −14% |
Ground conditions and code in Los Angeles
Permits in Los Angeles
A residential permit for this work typically runs around $900 in California, and metro jurisdictions like Los Angeles usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Los Angeles building department before work begins.
Hiring in Los Angeles
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in California.
Frequently asked questions
How much does privacy fence cost in Los Angeles?
In 2026, privacy fence costs $31.63 to $75.92 per linear ft in Los Angeles. For a 150-foot run, the installed total typically lands between $4,745 and $11,389.
Is Los Angeles more expensive than the rest of California?
Yes. Los Angeles runs about 14% above the California statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Los Angeles?
Most work of this type and value requires a permit. Budget around $900 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Los Angeles?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →