Privacy Fence costs $24.37 to $58.48 per linear ft in Augusta in 2026. For a 150-foot run, expect $3,655 – $8,772 installed, typically near $6,213. That is about 1% above the Georgia state average.
Augusta privacy fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Augusta costs more than the rest of Georgia
Augusta carries roughly a 1% premium over the Georgia statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Georgia averages $24.13 to $57.90 per linear ft, against $24.37 to $58.48 inside Augusta. Suburbs on the metro fringe usually fall between the two.
Privacy Fence cost by project size in Augusta
| Project size | Augusta range | Typical |
|---|---|---|
| 50 ft | $1,218 – $2,924 | $2,071 |
| 100 ft | $2,437 – $5,848 | $4,142 |
| 150 ft | $3,655 – $8,772 | $6,213 |
| 200 ft | $4,873 – $11,696 | $8,285 |
| 250 ft | $6,092 – $14,620 | $10,356 |
| 300 ft | $7,310 – $17,544 | $12,427 |
| 400 ft | $9,747 – $23,392 | $16,569 |
| 500 ft | $12,183 – $29,240 | $20,711 |
Augusta compared with other Georgia markets
| Area | Cost per linear ft | vs Augusta |
|---|---|---|
| Atlanta | $27.50 – $66.01 | +13% |
| Savannah | $25.09 – $60.22 | +3% |
| Georgia average | $24.13 – $57.90 | −1% |
Ground conditions and code in Augusta
Permits in Augusta
A residential permit for this work typically runs around $400 in Georgia, and metro jurisdictions like Augusta usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Augusta building department before work begins.
Hiring in Augusta
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Georgia.
Frequently asked questions
How much does privacy fence cost in Augusta?
In 2026, privacy fence costs $24.37 to $58.48 per linear ft in Augusta. For a 150-foot run, the installed total typically lands between $3,655 and $8,772.
Is Augusta more expensive than the rest of Georgia?
Yes. Augusta runs about 1% above the Georgia statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Augusta?
Most work of this type and value requires a permit. Budget around $400 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Augusta?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →