Metal Roof costs $9.47 to $23.14 per sq ft in Riverside in 2026. For a 400 sq ft project, expect $3,786 – $9,255 installed, typically near $6,520. That is about 4% below the California average.
Riverside metal roof calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Riverside runs below the California average
Construction wages in Riverside average $34.66 per hour against $37.64 statewide. Riverside sits below the California average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 50% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Metal Roof cost by project size in Riverside
| Project size | Riverside range | Typical |
|---|---|---|
| 100 sq ft | $947 – $2,314 | $1,630 |
| 200 sq ft | $1,893 – $4,627 | $3,260 |
| 300 sq ft | $2,840 – $6,941 | $4,890 |
| 400 sq ft | $3,786 – $9,255 | $6,520 |
| 600 sq ft | $5,679 – $13,882 | $9,781 |
| 800 sq ft | $7,572 – $18,510 | $13,041 |
| 1,000 sq ft | $9,465 – $23,137 | $16,301 |
| 1,500 sq ft | $14,198 – $34,705 | $24,452 |
Where the money goes
For a 400 sq ft project in Riverside at roughly $6,520, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 50% | $3,260 |
| Materials | 36% | $2,347 |
| Site prep & equipment | 8% | $522 |
| Overhead, disposal & finishing | 6% | $391 |
Riverside compared with other California markets
| Area | Cost per sq ft | vs Riverside |
|---|---|---|
| Los Angeles | $9.81 – $23.98 | +4% |
| San Francisco | $10.75 – $26.29 | +14% |
| San Diego | $9.73 – $23.80 | +3% |
| Sacramento | $9.72 – $23.76 | +3% |
| California average | $9.89 – $24.18 | +4% |
Ground conditions and code in Riverside
Permits in Riverside
A residential permit for this work typically runs around $900 in California. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Riverside building department before work begins.
Hiring in Riverside
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in California.
Frequently asked questions
How much does metal roof cost in Riverside?
In 2026, metal roof costs $9.47 to $23.14 per sq ft in Riverside. For a 400 sq ft project, the installed total typically lands between $3,786 and $9,255.
Is Riverside more expensive than the rest of California?
No. Riverside actually runs about 4% below the California average. Local construction wages are $34.66/hr against $37.64/hr statewide.
Do I need a permit in Riverside?
Most work of this type and value requires a permit. Budget around $900 in California and allow extra time for review in metro jurisdictions.
How do I compare quotes in Riverside?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full metal roof calculator →