Heat Pump Cost in Twin Falls, ID (2026)

HomeHVACIdaho › Twin Falls
Heat Pump Cost in Twin Falls, ID (2026)
BLS OEWS 2025 wage data · updated August 2026
Twin Falls · installed
$5,105 – $12,066

Heat Pump costs $5,105 to $12,066 in Twin Falls in 2026. For an average 1,800 sq ft home, expect $5,105 – $12,066 installed, typically near $8,585. That is about 4% below the Idaho average.

Typical system
$8,585
vs state average
−4%
Local construction wage
$25.49
Climate zone
IECC zone 5 (cold)

Twin Falls heat pump calculator

Estimated installed cost

Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.

Why Twin Falls runs below the Idaho average

Construction wages in Twin Falls average $25.49 per hour against $28.31 statewide. Twin Falls sits below the Idaho average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.

Labor is about 38% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.

Heat Pump cost by project size in Twin Falls

Project sizeTwin Falls rangeTypical
1,000 sq ft home$2,836 – $6,703$4,770
1,400 sq ft home$3,970 – $9,385$6,677
1,800 sq ft home$5,105 – $12,066$8,585
2,200 sq ft home$6,239 – $14,747$10,493
2,600 sq ft home$7,374 – $17,428$12,401
3,000 sq ft home$8,508 – $20,110$14,309

Where the money goes

For an average 1,800 sq ft home in Twin Falls at roughly $8,585, a typical bill splits like this:

Line itemShareCost
Labor38%$3,262
Materials48%$4,121
Site prep & equipment8%$687
Overhead, disposal & finishing6%$515

Twin Falls compared with other Idaho markets

AreaCost installedvs Twin Falls
Boise$5,312 – $12,555+4%
Idaho Falls$5,374 – $12,702+5%
Coeur d’Alene$5,355 – $12,658+5%
Pocatello$5,225 – $12,351+2%
Idaho average$5,293 – $12,511+4%

Climate and equipment sizing in Twin Falls

Twin Falls sits in IECC zone 5 (cold) which drives how much heating and cooling capacity a home here actually needs. Undersized equipment is the most common reason a cheap quote costs more over its life, and sizing should follow a Manual J load calculation rather than a rule of thumb.

Permits in Twin Falls

A residential permit for this work typically runs around $400 in Idaho. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Twin Falls building department before work begins.

Hiring in Twin Falls

Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Idaho.

Frequently asked questions

How much does heat pump cost in Twin Falls?

In 2026, heat pump costs $5,105 to $12,066 in Twin Falls. For an average 1,800 sq ft home, the installed total typically lands between $5,105 and $12,066.

Is Twin Falls more expensive than the rest of Idaho?

No. Twin Falls actually runs about 4% below the Idaho average. Local construction wages are $25.49/hr against $28.31/hr statewide.

Do I need a permit in Twin Falls?

Most work of this type and value requires a permit. Budget around $400 in Idaho and allow extra time for review in metro jurisdictions.

How do I compare quotes in Twin Falls?

Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full heat pump calculator →

Methodology. Local pricing applies the Twin Falls construction wage from the BLS Occupational Employment and Wage Statistics (2025 release, $25.49/hr) to the labor share of a national 2026 cost baseline. Materials are held at national prices. Figures refresh automatically with each BLS release. Planning estimates, not quotes. See our full methodology.

Leave a Comment