Heat Pump costs $5,895 to $13,933 in Burlington in 2026. For an average 1,800 sq ft home, expect $5,895 – $13,933 installed, typically near $9,914. That is about 8% above the Vermont state average.
Burlington heat pump calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Burlington costs more than the rest of Vermont
Burlington carries roughly a 8% premium over the Vermont statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 38% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Vermont averages $5,458 to $12,901, against $5,895 to $13,933 inside Burlington. Suburbs on the metro fringe usually fall between the two.
Heat Pump cost by project size in Burlington
| Project size | Burlington range | Typical |
|---|---|---|
| Small home (~1,000 sq ft) | $4,422 – $10,451 | $7,436 |
| Average home (~1,800 sq ft) | $5,895 – $13,934 | $9,915 |
| Large home (~2,600 sq ft) | $7,959 – $18,812 | $13,385 |
| Very large home (~3,500 sq ft) | $10,022 – $23,688 | $16,854 |
Where the money actually goes
For an average 1,800 sq ft home in Burlington at roughly $9,914, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 38% | $3,767 |
| Materials | 47% | $4,611 |
| Site prep & equipment | 9% | $922 |
| Overhead, disposal & finishing | 6% | $615 |
The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting preparation, not a genuine bargain.
Burlington compared with other Vermont markets
| Area | Cost installed | vs Burlington |
|---|---|---|
| Rutland | $5,458 – $12,901 | −7% |
| Montpelier | $5,567 – $13,159 | −6% |
| Vermont average | $5,458 – $12,901 | −7% |
Climate and equipment sizing in Burlington
Permits in Burlington
A residential permit for this work typically runs around $400 in Vermont, and metro jurisdictions like Burlington usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Burlington building department before work begins.
Hiring in Burlington
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same scope and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Vermont.
Frequently asked questions
How much does heat pump cost in Burlington?
In 2026, heat pump costs $5,895 to $13,933 in Burlington. For an average 1,800 sq ft home, the installed total typically lands between $5,895 and $13,933.
Is Burlington more expensive than the rest of Vermont?
Yes. Burlington runs about 8% above the Vermont statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Burlington?
Most work of this type and value requires a permit. Budget around $400 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Burlington?
Insist on three written, itemised quotes covering identical scope, materials, and preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full heat pump calculator →