Concrete Driveway costs $9.95 to $22.38 per sq ft in San Diego in 2026. For a 400 sq ft project, expect $3,978 – $8,951 installed, typically near $6,465. That is about 12% above the California state average.
San Diego concrete driveway cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why San Diego costs more than the rest of California
San Diego carries roughly a 12% premium over the California statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, California averages $8.88 to $19.98 per sq ft, against $9.95 to $22.38 inside San Diego. Suburbs on the metro fringe usually fall between the two.
Concrete Driveway cost by project size in San Diego
| Project size | San Diego range | Typical |
|---|---|---|
| 10×10 (100 sq ft) | $995 – $2,238 | $1,616 |
| 12×12 (144 sq ft) | $1,432 – $3,222 | $2,327 |
| 12×16 (192 sq ft) | $1,910 – $4,296 | $3,103 |
| 16×20 (320 sq ft) | $3,183 – $7,161 | $5,172 |
| 20×20 (400 sq ft) | $3,978 – $8,951 | $6,465 |
| 24×24 (576 sq ft) | $5,729 – $12,889 | $9,309 |
| 30×40 (1,200 sq ft) | $11,935 – $26,853 | $19,394 |
San Diego compared with other California markets
| Area | Cost per sq ft | vs San Diego |
|---|---|---|
| Los Angeles | $10.12 – $22.78 | +2% |
| San Francisco | $11.54 – $25.97 | +16% |
| California average | $8.88 – $19.98 | −12% |
Ground conditions and code in San Diego
Permits in San Diego
A residential permit for this work typically runs around $900 in California, and metro jurisdictions like San Diego usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the San Diego building department before work begins.
Hiring in San Diego
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in California.
Frequently asked questions
How much does concrete driveway cost in San Diego?
In 2026, concrete driveway costs $9.95 to $22.38 per sq ft in San Diego. For a 400 sq ft project, the installed total typically lands between $3,978 and $8,951.
Is San Diego more expensive than the rest of California?
Yes. San Diego runs about 12% above the California statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in San Diego?
Most work of this type and value requires a permit. Budget around $900 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in San Diego?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full concrete driveway calculator →