Concrete Driveway costs $7.83 to $17.63 per sq ft in Greensboro in 2026. For a 400 sq ft project, expect $3,133 – $7,050 installed, typically near $5,092. That is about 2% above the North Carolina state average.
Greensboro concrete driveway cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Greensboro costs more than the rest of North Carolina
Greensboro carries roughly a 2% premium over the North Carolina statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, North Carolina averages $7.68 to $17.28 per sq ft, against $7.83 to $17.63 inside Greensboro. Suburbs on the metro fringe usually fall between the two.
Concrete Driveway cost by project size in Greensboro
| Project size | Greensboro range | Typical |
|---|---|---|
| 10×10 (100 sq ft) | $783 – $1,763 | $1,273 |
| 12×12 (144 sq ft) | $1,128 – $2,538 | $1,833 |
| 12×16 (192 sq ft) | $1,504 – $3,384 | $2,444 |
| 16×20 (320 sq ft) | $2,507 – $5,640 | $4,073 |
| 20×20 (400 sq ft) | $3,133 – $7,050 | $5,092 |
| 24×24 (576 sq ft) | $4,512 – $10,152 | $7,332 |
| 30×40 (1,200 sq ft) | $9,400 – $21,151 | $15,276 |
Greensboro compared with other North Carolina markets
| Area | Cost per sq ft | vs Greensboro |
|---|---|---|
| Charlotte | $8.52 – $19.18 | +9% |
| Raleigh | $8.45 – $19.01 | +8% |
| North Carolina average | $7.68 – $17.28 | −2% |
Ground conditions and code in Greensboro
Permits in Greensboro
A residential permit for this work typically runs around $400 in North Carolina, and metro jurisdictions like Greensboro usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Greensboro building department before work begins.
Hiring in Greensboro
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in North Carolina.
Frequently asked questions
How much does concrete driveway cost in Greensboro?
In 2026, concrete driveway costs $7.83 to $17.63 per sq ft in Greensboro. For a 400 sq ft project, the installed total typically lands between $3,133 and $7,050.
Is Greensboro more expensive than the rest of North Carolina?
Yes. Greensboro runs about 2% above the North Carolina statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Greensboro?
Most work of this type and value requires a permit. Budget around $400 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Greensboro?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full concrete driveway calculator →