Concrete Driveway Cost in Columbus, GA (2026)

HomeConcreteGeorgia › Columbus
Concrete Driveway Cost in Columbus, GA (2026)
BLS OEWS 2025 wage data · updated August 2026
Columbus · per sq ft
$6.99 – $15.73

Concrete Driveway costs $6.99 to $15.73 per sq ft in Columbus in 2026. For a 400 sq ft project, expect $2,797 – $6,294 installed, typically near $4,545. That is about 6% below the Georgia average.

Typical sq ft
$11.36
vs state average
−6%
Local construction wage
$23.52
Frost depth
8 in

Columbus concrete driveway calculator

Estimated installed cost

Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.

Why Columbus runs below the Georgia average

Construction wages in Columbus average $23.52 per hour against $27.12 statewide. Columbus sits below the Georgia average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.

Labor is about 50% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.

Concrete Driveway cost by project size in Columbus

Project sizeColumbus rangeTypical
100 sq ft$699 – $1,573$1,136
200 sq ft$1,399 – $3,147$2,273
300 sq ft$2,098 – $4,720$3,409
400 sq ft$2,797 – $6,294$4,545
600 sq ft$4,196 – $9,440$6,818
800 sq ft$5,594 – $12,587$9,091
1,000 sq ft$6,993 – $15,734$11,363
1,500 sq ft$10,489 – $23,601$17,045

Where the money goes

For a 400 sq ft project in Columbus at roughly $4,545, a typical bill splits like this:

Line itemShareCost
Labor50%$2,273
Materials36%$1,636
Site prep & equipment8%$364
Overhead, disposal & finishing6%$273

Columbus compared with other Georgia markets

AreaCost per sq ftvs Columbus
Atlanta$7.60 – $17.09+9%
Augusta$7.41 – $16.68+6%
Savannah$7.39 – $16.63+6%
Gainesville$7.35 – $16.54+5%
Georgia average$7.45 – $16.77+7%

Ground conditions and code in Columbus

Columbus sits in IECC zone 3 (warm) with a design frost depth of about 8 inches. Footings and posts must extend below that line, which adds excavation depth and concrete volume that warm-climate estimates leave out.

Permits in Columbus

A residential permit for this work typically runs around $400 in Georgia. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Columbus building department before work begins.

Hiring in Columbus

Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Georgia.

Frequently asked questions

How much does concrete driveway cost in Columbus?

In 2026, concrete driveway costs $6.99 to $15.73 per sq ft in Columbus. For a 400 sq ft project, the installed total typically lands between $2,797 and $6,294.

Is Columbus more expensive than the rest of Georgia?

No. Columbus actually runs about 6% below the Georgia average. Local construction wages are $23.52/hr against $27.12/hr statewide.

Do I need a permit in Columbus?

Most work of this type and value requires a permit. Budget around $400 in Georgia and allow extra time for review in metro jurisdictions.

How do I compare quotes in Columbus?

Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.

Nearby markets

Open the full concrete driveway calculator →

Methodology. Local pricing applies the Columbus construction wage from the BLS Occupational Employment and Wage Statistics (2025 release, $23.52/hr) to the labor share of a national 2026 cost baseline. Materials are held at national prices. Figures refresh automatically with each BLS release. Planning estimates, not quotes. See our full methodology.

Leave a Comment