Chain Link Fence costs $11.90 to $29.76 per linear ft in Fargo in 2026. For a 150-foot run, expect $1,786 – $4,464 installed, typically near $3,125. That is about 2% below the North Dakota average.
Fargo chain link fence calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Fargo runs below the North Dakota average
Construction wages in Fargo average $30.87 per hour against $32.12 statewide. Fargo sits below the North Dakota average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 45% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Chain Link Fence cost by project size in Fargo
| Project size | Fargo range | Typical |
|---|---|---|
| 50 ft | $595 – $1,488 | $1,042 |
| 100 ft | $1,190 – $2,976 | $2,083 |
| 150 ft | $1,786 – $4,464 | $3,125 |
| 200 ft | $2,381 – $5,952 | $4,166 |
| 250 ft | $2,976 – $7,440 | $5,208 |
| 300 ft | $3,571 – $8,928 | $6,249 |
| 400 ft | $4,761 – $11,904 | $8,332 |
| 500 ft | $5,952 – $14,879 | $10,416 |
Where the money goes
For a 150-foot run in Fargo at roughly $3,125, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 45% | $1,406 |
| Materials | 41% | $1,281 |
| Site prep & equipment | 8% | $250 |
| Overhead, disposal & finishing | 6% | $187 |
Fargo compared with other North Dakota markets
| Area | Cost per linear ft | vs Fargo |
|---|---|---|
| West North Dakota nonmetropolitan area | $12.49 – $31.24 | +5% |
| Bismarck | $11.84 – $29.61 | −1% |
| East North Dakota nonmetropolitan area | $11.77 – $29.43 | −1% |
| Minot | $11.92 – $29.80 | 0% |
| North Dakota average | $12.12 – $30.30 | +2% |
Ground conditions and code in Fargo
Permits in Fargo
A residential permit for this work typically runs around $300 in North Dakota. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Fargo building department before work begins.
Hiring in Fargo
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in North Dakota.
Frequently asked questions
How much does chain link fence cost in Fargo?
In 2026, chain link fence costs $11.90 to $29.76 per linear ft in Fargo. For a 150-foot run, the installed total typically lands between $1,786 and $4,464.
Is Fargo more expensive than the rest of North Dakota?
No. Fargo actually runs about 2% below the North Dakota average. Local construction wages are $30.87/hr against $32.12/hr statewide.
Do I need a permit in Fargo?
Most work of this type and value requires a permit. Budget around $300 in North Dakota and allow extra time for review in metro jurisdictions.
How do I compare quotes in Fargo?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full chain link fence calculator →