Chain Link Fence costs $12.58 to $31.46 per linear ft in Concord in 2026. For a 150-foot run, expect $1,887 – $4,719 installed, typically near $3,303. That is about 3% above the New Hampshire state average.
Concord chain link fence calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Concord costs more than the rest of New Hampshire
Concord carries roughly a 3% premium over the New Hampshire statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 45% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, New Hampshire averages $12.22 to $30.54 per linear ft, against $12.58 to $31.46 inside Concord. Suburbs on the metro fringe usually fall between the two.
Chain Link Fence cost by project size in Concord
| Project size | Concord range | Typical |
|---|---|---|
| 50 ft | $629 – $1,572 | $1,100 |
| 100 ft | $1,258 – $3,144 | $2,201 |
| 150 ft | $1,886 – $4,716 | $3,301 |
| 200 ft | $2,515 – $6,288 | $4,402 |
| 250 ft | $3,144 – $7,860 | $5,502 |
| 300 ft | $3,773 – $9,432 | $6,602 |
| 400 ft | $5,030 – $12,576 | $8,803 |
| 500 ft | $6,288 – $15,720 | $11,004 |
Where the money actually goes
For a 150-foot run in Concord at roughly $3,303, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 45% | $1,486 |
| Materials | 41% | $1,363 |
| Site prep & equipment | 8% | $273 |
| Overhead, disposal & finishing | 6% | $181 |
The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting preparation, not a genuine bargain.
Concord compared with other New Hampshire markets
| Area | Cost per linear ft | vs Concord |
|---|---|---|
| Manchester | $13.07 – $32.68 | +4% |
| Nashua | $13.32 – $33.29 | +6% |
| New Hampshire average | $12.22 – $30.54 | −3% |
Frost depth and code requirements in Concord
Permits in Concord
A residential permit for this work typically runs around $450 in New Hampshire, and metro jurisdictions like Concord usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Concord building department before work begins.
Hiring in Concord
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same scope and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in New Hampshire.
Frequently asked questions
How much does chain link fence cost in Concord?
In 2026, chain link fence costs $12.58 to $31.46 per linear ft in Concord. For a 150-foot run, the installed total typically lands between $1,887 and $4,719.
Is Concord more expensive than the rest of New Hampshire?
Yes. Concord runs about 3% above the New Hampshire statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Concord?
Most work of this type and value requires a permit. Budget around $450 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Concord?
Insist on three written, itemised quotes covering identical scope, materials, and preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full chain link fence calculator →