Vinyl Fence costs $27.76 to $59.50 per linear ft in Rutland in 2026. For a 150-foot run, expect $4,164 – $8,925 installed, typically near $6,545. That is essentially in line with the Vermont state average.
Rutland vinyl fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Rutland costs more than the rest of Vermont
Rutland carries essentially the same rate as the Vermont statewide figure. Wages, permitting, and site access here track close to the statewide norm, so the premium metro buyers often pay elsewhere is much smaller in Rutland.
Statewide, Vermont averages $27.76 to $59.50 per linear ft, against $27.76 to $59.50 inside Rutland. Suburbs on the metro fringe usually fall between the two.
Vinyl Fence cost by project size in Rutland
| Project size | Rutland range | Typical |
|---|---|---|
| 50 ft | $1,388 – $2,975 | $2,182 |
| 100 ft | $2,776 – $5,950 | $4,363 |
| 150 ft | $4,164 – $8,925 | $6,545 |
| 200 ft | $5,552 – $11,900 | $8,726 |
| 250 ft | $6,940 – $14,875 | $10,908 |
| 300 ft | $8,328 – $17,850 | $13,089 |
| 400 ft | $11,104 – $23,800 | $17,452 |
| 500 ft | $13,880 – $29,750 | $21,815 |
Where the money actually goes
For a 150-foot run in Rutland at roughly $6,545, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 42% | $2,749 |
| Materials | 44% | $2,880 |
| Site prep & equipment | 9% | $589 |
| Overhead, disposal & finishing | 6% | $393 |
The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting site prep, not a genuine bargain.
Rutland compared with other Vermont markets
| Area | Cost per linear ft | vs Rutland |
|---|---|---|
| Burlington | $29.99 – $64.26 | +8% |
| Montpelier | $28.32 – $60.69 | +2% |
| Vermont average | $27.76 – $59.50 | 0% |
Ground conditions and code in Rutland
Permits in Rutland
A residential permit for this work typically runs around $400 in Vermont, and metro jurisdictions like Rutland usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Rutland building department before work begins.
Hiring in Rutland
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Vermont.
Frequently asked questions
How much does vinyl fence cost in Rutland?
In 2026, vinyl fence costs $27.76 to $59.50 per linear ft in Rutland. For a 150-foot run, the installed total typically lands between $4,164 and $8,925.
Is Rutland more expensive than the rest of Vermont?
Not meaningfully. Rutland prices essentially in line with the Vermont statewide average.
Do I need a permit in Rutland?
Most work of this type and value requires a permit. Budget around $400 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Rutland?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full vinyl fence calculator →