Privacy Fence costs $26.22 to $62.92 per linear ft in Spokane in 2026. For a 150-foot run, expect $3,933 – $9,439 installed, typically near $6,686. That is about 7% below the Washington average.
Spokane privacy fence calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Spokane runs below the Washington average
Construction wages in Spokane average $34.50 per hour against $39.60 statewide. Spokane sits below the Washington average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 50% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Privacy Fence cost by project size in Spokane
| Project size | Spokane range | Typical |
|---|---|---|
| 50 ft | $1,311 – $3,146 | $2,229 |
| 100 ft | $2,622 – $6,292 | $4,457 |
| 150 ft | $3,933 – $9,439 | $6,686 |
| 200 ft | $5,244 – $12,585 | $8,914 |
| 250 ft | $6,555 – $15,731 | $11,143 |
| 300 ft | $7,865 – $18,877 | $13,371 |
| 400 ft | $10,487 – $25,170 | $17,828 |
| 500 ft | $13,109 – $31,462 | $22,286 |
Where the money goes
For a 150-foot run in Spokane at roughly $6,686, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 50% | $3,343 |
| Materials | 36% | $2,407 |
| Site prep & equipment | 8% | $535 |
| Overhead, disposal & finishing | 6% | $401 |
Spokane compared with other Washington markets
| Area | Cost per linear ft | vs Spokane |
|---|---|---|
| Seattle | $29.24 – $70.18 | +12% |
| Kennewick | $28.38 – $68.10 | +8% |
| Bremerton | $27.70 – $66.48 | +6% |
| Bellingham | $28.16 – $67.57 | +7% |
| Washington average | $28.25 – $67.80 | +8% |
Ground conditions and code in Spokane
Permits in Spokane
A residential permit for this work typically runs around $700 in Washington. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Spokane building department before work begins.
Hiring in Spokane
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Washington.
Frequently asked questions
How much does privacy fence cost in Spokane?
In 2026, privacy fence costs $26.22 to $62.92 per linear ft in Spokane. For a 150-foot run, the installed total typically lands between $3,933 and $9,439.
Is Spokane more expensive than the rest of Washington?
No. Spokane actually runs about 7% below the Washington average. Local construction wages are $34.50/hr against $39.60/hr statewide.
Do I need a permit in Spokane?
Most work of this type and value requires a permit. Budget around $700 in Washington and allow extra time for review in metro jurisdictions.
How do I compare quotes in Spokane?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →