Privacy Fence costs $28.60 to $68.64 per linear ft in Saint Paul in 2026. For a 150-foot run, expect $4,290 – $10,296 installed, typically near $7,293. That is about 10% above the Minnesota state average.
Saint Paul privacy fence cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Saint Paul costs more than the rest of Minnesota
Saint Paul carries roughly a 10% premium over the Minnesota statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Minnesota averages $26.00 to $62.40 per linear ft, against $28.60 to $68.64 inside Saint Paul. Suburbs on the metro fringe usually fall between the two.
Privacy Fence cost by project size in Saint Paul
| Project size | Saint Paul range | Typical |
|---|---|---|
| 50 ft | $1,430 – $3,432 | $2,431 |
| 100 ft | $2,860 – $6,864 | $4,862 |
| 150 ft | $4,290 – $10,296 | $7,293 |
| 200 ft | $5,720 – $13,728 | $9,724 |
| 250 ft | $7,150 – $17,160 | $12,155 |
| 300 ft | $8,580 – $20,592 | $14,586 |
| 400 ft | $11,440 – $27,456 | $19,448 |
| 500 ft | $14,300 – $34,320 | $24,310 |
Saint Paul compared with other Minnesota markets
| Area | Cost per linear ft | vs Saint Paul |
|---|---|---|
| Minneapolis | $29.12 – $69.89 | +2% |
| Rochester | $27.04 – $64.90 | -5% |
| Minnesota average | $26.00 – $62.40 | −10% |
Ground conditions and code in Saint Paul
Permits in Saint Paul
A residential permit for this work typically runs around $500 in Minnesota, and metro jurisdictions like Saint Paul usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Saint Paul building department before work begins.
Hiring in Saint Paul
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Minnesota.
Frequently asked questions
How much does privacy fence cost in Saint Paul?
In 2026, privacy fence costs $28.60 to $68.64 per linear ft in Saint Paul. For a 150-foot run, the installed total typically lands between $4,290 and $10,296.
Is Saint Paul more expensive than the rest of Minnesota?
Yes. Saint Paul runs about 10% above the Minnesota statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Saint Paul?
Most work of this type and value requires a permit. Budget around $500 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Saint Paul?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full privacy fence calculator →