Stamped Concrete costs $11.78 to $25.37 per sq ft in Gainesville in 2026. For a 400 sq ft project, expect $4,711 – $10,147 installed, typically near $7,429. That is about 2% below the Georgia average.
Gainesville stamped concrete calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Gainesville runs below the Georgia average
Construction wages in Gainesville average $26.32 per hour against $27.12 statewide. Gainesville sits below the Georgia average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 58% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Stamped Concrete cost by project size in Gainesville
| Project size | Gainesville range | Typical |
|---|---|---|
| 100 sq ft | $1,178 – $2,537 | $1,857 |
| 200 sq ft | $2,356 – $5,074 | $3,715 |
| 300 sq ft | $3,533 – $7,611 | $5,572 |
| 400 sq ft | $4,711 – $10,147 | $7,429 |
| 600 sq ft | $7,067 – $15,221 | $11,144 |
| 800 sq ft | $9,423 – $20,295 | $14,859 |
| 1,000 sq ft | $11,778 – $25,369 | $18,573 |
| 1,500 sq ft | $17,667 – $38,053 | $27,860 |
Where the money goes
For a 400 sq ft project in Gainesville at roughly $7,429, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 58% | $4,309 |
| Materials | 28% | $2,080 |
| Site prep & equipment | 8% | $594 |
| Overhead, disposal & finishing | 6% | $446 |
Gainesville compared with other Georgia markets
| Area | Cost per sq ft | vs Gainesville |
|---|---|---|
| Atlanta | $12.24 – $26.36 | +4% |
| Augusta | $11.90 – $25.62 | +1% |
| Savannah | $11.86 – $25.54 | +1% |
| Columbus | $11.10 – $23.91 | −6% |
| Georgia average | $11.97 – $25.78 | +2% |
Ground conditions and code in Gainesville
Permits in Gainesville
A residential permit for this work typically runs around $400 in Georgia. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Gainesville building department before work begins.
Hiring in Gainesville
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Georgia.
Frequently asked questions
How much does stamped concrete cost in Gainesville?
In 2026, stamped concrete costs $11.78 to $25.37 per sq ft in Gainesville. For a 400 sq ft project, the installed total typically lands between $4,711 and $10,147.
Is Gainesville more expensive than the rest of Georgia?
No. Gainesville actually runs about 2% below the Georgia average. Local construction wages are $26.32/hr against $27.12/hr statewide.
Do I need a permit in Gainesville?
Most work of this type and value requires a permit. Budget around $400 in Georgia and allow extra time for review in metro jurisdictions.
How do I compare quotes in Gainesville?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full stamped concrete calculator →