Stamped Concrete costs $14.63 to $31.51 per sq ft in Bremerton in 2026. For a 400 sq ft project, expect $5,851 – $12,602 installed, typically near $9,227. That is about 2% below the Washington average.
Bremerton stamped concrete calculator
Planning estimate. Wage index applies to the labor share only; materials held at national prices. Get three written quotes.
Why Bremerton runs below the Washington average
Construction wages in Bremerton average $38.23 per hour against $39.60 statewide. Bremerton sits below the Washington average because the statewide figure is pulled up by higher-wage metros elsewhere in the state.
Labor is about 58% of the installed cost on this type of work, and it is the part that actually moves between markets. Materials are priced by national manufacturers and barely shift, which is why the gap between metros is narrower than wage differences alone suggest.
Stamped Concrete cost by project size in Bremerton
| Project size | Bremerton range | Typical |
|---|---|---|
| 100 sq ft | $1,463 – $3,151 | $2,307 |
| 200 sq ft | $2,926 – $6,301 | $4,613 |
| 300 sq ft | $4,388 – $9,452 | $6,920 |
| 400 sq ft | $5,851 – $12,602 | $9,227 |
| 600 sq ft | $8,777 – $18,904 | $13,840 |
| 800 sq ft | $11,702 – $25,205 | $18,454 |
| 1,000 sq ft | $14,628 – $31,506 | $23,067 |
| 1,500 sq ft | $21,942 – $47,259 | $34,601 |
Where the money goes
For a 400 sq ft project in Bremerton at roughly $9,227, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 58% | $5,352 |
| Materials | 28% | $2,584 |
| Site prep & equipment | 8% | $738 |
| Overhead, disposal & finishing | 6% | $554 |
Bremerton compared with other Washington markets
| Area | Cost per sq ft | vs Bremerton |
|---|---|---|
| Seattle | $15.56 – $33.51 | +6% |
| Spokane | $13.73 – $29.58 | −6% |
| Kennewick | $15.04 – $32.39 | +3% |
| Bellingham | $14.90 – $32.10 | +2% |
| Washington average | $14.96 – $32.22 | +2% |
Ground conditions and code in Bremerton
Permits in Bremerton
A residential permit for this work typically runs around $700 in Washington. Permit cost is rarely included in a contractor quote, so budget it separately and confirm scope with the Bremerton building department before work begins.
Hiring in Bremerton
Get three written, itemised quotes from licensed and insured contractors, each specifying the same scope and grade of material. Ask for local references and check the licence is current in Washington.
Frequently asked questions
How much does stamped concrete cost in Bremerton?
In 2026, stamped concrete costs $14.63 to $31.51 per sq ft in Bremerton. For a 400 sq ft project, the installed total typically lands between $5,851 and $12,602.
Is Bremerton more expensive than the rest of Washington?
No. Bremerton actually runs about 2% below the Washington average. Local construction wages are $38.23/hr against $39.60/hr statewide.
Do I need a permit in Bremerton?
Most work of this type and value requires a permit. Budget around $700 in Washington and allow extra time for review in metro jurisdictions.
How do I compare quotes in Bremerton?
Get three written, itemised quotes covering identical scope and materials. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full stamped concrete calculator →