Wood Fence costs $22.45 to $56.11 per linear ft in Jersey City in 2026. For a 150-foot run, expect $3,368 – $8,417 installed, typically near $5,892. That is about 16% above the New Jersey state average.
Jersey City wood fence calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Jersey City costs more than the rest of New Jersey
Jersey City carries roughly a 16% premium over the New Jersey statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, New Jersey averages $19.35 to $48.38 per linear ft, against $22.45 to $56.11 inside Jersey City. Suburbs on the metro fringe usually fall between the two.
Wood Fence cost by project size in Jersey City
| Project size | Jersey City range | Typical |
|---|---|---|
| 50 ft | $1,122 – $2,807 | $1,964 |
| 100 ft | $2,245 – $5,613 | $3,928 |
| 150 ft | $3,367 – $8,418 | $5,893 |
| 200 ft | $4,490 – $11,225 | $7,858 |
| 250 ft | $5,612 – $14,032 | $9,822 |
| 300 ft | $6,735 – $16,838 | $11,787 |
| 400 ft | $8,980 – $22,450 | $15,715 |
| 500 ft | $11,225 – $28,063 | $19,643 |
Where the money actually goes
For a 150-foot run in Jersey City at roughly $5,892, a typical bill splits like this:
| Line item | Share | Cost |
|---|---|---|
| Labor | 50% | $2,946 |
| Materials | 38% | $2,210 |
| Site prep & equipment | 8% | $442 |
| Overhead, disposal & finishing | 5% | $295 |
The labor share is why identical projects diverge so sharply between states. It is also why a bid that comes in far below these numbers usually means a thinner specification or a crew cutting preparation, not a genuine bargain.
Jersey City compared with other New Jersey markets
| Area | Cost per linear ft | vs Jersey City |
|---|---|---|
| Newark | $21.67 – $54.18 | −3% |
| Trenton | $20.32 – $50.79 | −9% |
| New Jersey average | $19.35 – $48.38 | −14% |
Frost depth and code requirements in Jersey City
Permits in Jersey City
A residential permit for this work typically runs around $650 in New Jersey, and metro jurisdictions like Jersey City usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Jersey City building department before work begins.
Hiring in Jersey City
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same scope and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in New Jersey.
Frequently asked questions
How much does wood fence cost in Jersey City?
In 2026, wood fence costs $22.45 to $56.11 per linear ft in Jersey City. For a 150-foot run, the installed total typically lands between $3,368 and $8,417.
Is Jersey City more expensive than the rest of New Jersey?
Yes. Jersey City runs about 16% above the New Jersey statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Jersey City?
Most work of this type and value requires a permit. Budget around $650 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Jersey City?
Insist on three written, itemised quotes covering identical scope, materials, and preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full wood fence calculator →