Concrete Slab costs $5.89 to $11.78 per sq ft in Oklahoma City in 2026. For a 400 sq ft project, expect $2,356 – $4,712 installed, typically near $3,534. That is about 5% above the Oklahoma state average.
Oklahoma City concrete slab cost calculator
Planning estimate only. State pricing applies a construction wage index to the labor share; materials are held at national prices. Get three written quotes before committing.
Why Oklahoma City costs more than the rest of Oklahoma
Oklahoma City carries roughly a 5% premium over the Oklahoma statewide figure. Three things drive that gap. Metro wages run above the state average, and labor is about 50% of this bill. Permitting and inspection are slower and more expensive inside city limits. And site access is tighter, which means smaller equipment, more hand work, and sometimes street permits for deliveries.
Statewide, Oklahoma averages $5.61 to $11.22 per sq ft, against $5.89 to $11.78 inside Oklahoma City. Suburbs on the metro fringe usually fall between the two.
Concrete Slab cost by project size in Oklahoma City
| Project size | Oklahoma City range | Typical |
|---|---|---|
| 10×10 (100 sq ft) | $589 – $1,178 | $884 |
| 12×12 (144 sq ft) | $848 – $1,696 | $1,272 |
| 12×16 (192 sq ft) | $1,131 – $2,262 | $1,696 |
| 16×20 (320 sq ft) | $1,885 – $3,770 | $2,827 |
| 20×20 (400 sq ft) | $2,356 – $4,712 | $3,534 |
| 24×24 (576 sq ft) | $3,393 – $6,786 | $5,089 |
| 30×40 (1,200 sq ft) | $7,069 – $14,137 | $10,603 |
Oklahoma City compared with other Oklahoma markets
| Area | Cost per sq ft | vs Oklahoma City |
|---|---|---|
| Tulsa | $5.83 – $11.67 | -1% |
| Norman | $5.67 – $11.33 | -4% |
| Oklahoma average | $5.61 – $11.22 | −5% |
Ground conditions and code in Oklahoma City
Permits in Oklahoma City
A residential permit for this work typically runs around $300 in Oklahoma, and metro jurisdictions like Oklahoma City usually sit at the upper end of that range with longer review times. Permit cost is rarely included in a contractor quote, so add it separately. Confirm scope with the Oklahoma City building department before work begins.
Hiring in Oklahoma City
Get three written, itemised quotes from licensed and insured contractors, and make sure each specifies the same dimensions and the same grade of material. In a metro market, the cheapest bid often reflects a thinner specification or a crew travelling in from outside the area rather than a genuine saving. Ask for local references and check that the licence is current in Oklahoma.
Frequently asked questions
How much does concrete slab cost in Oklahoma City?
In 2026, concrete slab costs $5.89 to $11.78 per sq ft in Oklahoma City. For a 400 sq ft project, the installed total typically lands between $2,356 and $4,712.
Is Oklahoma City more expensive than the rest of Oklahoma?
Yes. Oklahoma City runs about 5% above the Oklahoma statewide average, driven by metro wage levels, permitting, and tighter site access.
Do I need a permit in Oklahoma City?
Most work of this type and value requires a permit. Budget around $300 and allow extra time for review, since metro jurisdictions are typically slower than rural ones.
How do I compare quotes in Oklahoma City?
Insist on three written, itemised quotes covering identical dimensions, materials, and scope of preparation. A bid far below the others usually signals a reduced specification rather than better value.
Nearby markets
Open the full concrete slab calculator →